Should there be any play in trailer wheel bearings?

Travel Trailers: Dexter bearing - Open Roads Forum1- rotate the wheel and slowly tighten nut to 50 lbs-ft of torque. and then finger tight and insert cotter pin at closes hole and I never have any play. A visual inspection of the bearings should have revealed any defects which usually There is another defect which occurs, usually with ball bearings called burnelling

How much play in wheel bearings?? - Texas Fishing ForumBefore putting my boat back on my trailer yesterday I grabbed the top of the There should be no play at all in the wheel or there should be no trailer bearings,grease,tighten or replace--need help,pleaseOct 31, 2007 — Does any one have any knowledge of trailer wheel bearings; I don't have the first clue. Is there susposed to be end play and if so how much is allowable or is it zero end play. any info at If should spin freely with no noise

How to Tell if a Trailer's Bearings Are Bad - It Still RunsAll bearings require a constant supply of lubrication, and must be periodically There should be a very slight amount of play in the wheel, typically 1/8-inch or 

Checking play in trailer bearings - The Hull Truth - BoatingOct 4, 2015 — When I checked for any play I found all 4 wheels had a bit of play in the berrings. ( wiggeling the I would think there should be no play at allHow to Pre-Load Trailer Wheel Bearings | Champion TrailersWinterizing Your Trailer: Storage. There's no reason not to keep your boat on a trailer during the summer, when you're heading to nearb …

How much is too much play in trailer bearings? - OffshoreonlyJun 23, 2013 — Trucks, Trailers and Transportation - How much is too much play in trailer bearings? How could I get it any tighter or should I just take an impact to the axle nut? There will be slight play but not much. TO tight is just as bad as TO loose. Often when bearings go bad the race, spindle, hub or drum also are Inside tire wear & bearing play in - Open Roads ForumAug 18, 2018 — Heading off to Montreal on Friday so brought the trailer home today to adjust brakes and noticed Hope I don't find any issues and can just clean them, pack them and be done in an afternoon. Anything else I should look at while I am there. Yes a loose or bad bearing could cause inside tire wear

Wheel bearing play: Is this too loose? (video) - Airstream ForumsSep 4, 2014 — No new races or bearings, just kept the stock ones. When. Should have no discernible play like that. See if there's any play in the wheel. If not, back it You can find different thickness of shims at a trailer or tranny placeProper Way to Tighten Trailer Spindle of Castle Nut |Jan 3, 2015 — There should be a little bit of end play (wobble), but not much. At this point, o make sure Any end play should be barely noticeable. When you are Replacing the Bearing, Races and Seals on a Trailer Hub. Cleaning and